Refine
Language
- English (3)
Has Fulltext
- yes (3)
Is part of the Bibliography
- yes (3)
Keywords
- Data quality (1)
- Description standards (1)
- Discussion (1)
- Material characterization (1)
- Metadata (1)
- Nanomaterials (1)
- Nanosafety (1)
- Regulation (1)
- Toxicology (1)
- Workshop (1)
Scientific Unit
Hydroxyapatite coatings need similarly shaped splats as building blocks and then a homogeneous microstructure to unravel the structural and chemical hierarchy for more refined improvements to implant surfaces. Coatings were thermally sprayed with differently sized powders (20–40, 40–63 and 63–80 µm) to produce flattened homogeneous splats. The surface was characterized for splat shape by profilometry and Atomic force microscopy (AFM), crystal size by AFM, crystal orientation by X-ray diffraction (XRD) and structural variations by XRD. Chemical composition was assessed by phase analysis, but variations in chemistry were detected by XRD and Raman spectroscopy. The resulting surface electrical potential was measured by Kelvin probe AFM. Five levels of structural hierarchy were suggested: the coating, the splat, oriented crystals, alternate layers of oxyapatite and hydroxyapatite (HAp) and the suggested anion orientation. Chemical hierarchy was present over a lower range of order for smaller splats. Coatings made from smaller splats exhibited a greater electrical potential, inferred to arise from oxyapatite, and supplemented by ordered OH− ions in a rehydroxylated surface layer. A model has been proposed to show the influence of structural hierarchy on the electrical surface potential. Structural hierarchy is proposed as a means to further refine the properties of implant surfaces.
Friction force microscopy was performed with oxidized or gold-coated silicon tips sliding on Au(111) or oxidized Si(100) surfaces in ultrahigh vacuum. We measured very low friction forces compared to adhesion forces and found a modulation of lateral forces reflecting the atomic structure of the surfaces. Holding the force-microscopy tip stationary for some time did not lead to an increase in static friction, i.e., no contact ageing was observed for these pairs of tip and surface. Passivating layers from tip or surface were removed in order to allow for contact ageing through the development of chemical bonds in the static contact. After removal of the passivating layers, tribochemical reactions resulted in strong friction forces and tip wear. Friction, wear, and the re-passivation by oxides are discussed based on results for the temporal development of friction forces, on images of the scanned area after friction force microscopy experiments, and on electron microscopy of the tips.
The partners of the research project NanoS-QM (Quality- and Description Standards for Nanosafety Research Data) identified and invited relevant experts from research institutions, federal agencies, and industry to evaluate the traceability of the results generated with the existing standards and quality criteria. During the discussion it emerged that numerous studies seem to be of insufficient quality for regulatory purposes or exhibit weaknesses with regard to data completeness. Deficiencies in study design could be avoided by more comprehensive use of appropriate standards, many of which already exist. The use of Electronic Laboratory Notebooks (ELNs) that allow for early collection of metadata and enrichment of datasets could be one solution to enable data re-use and simplify quality control. Generally, earlier provision and curation of data and metadata indicating their quality and completeness (e.g. guidelines, standards, standard operating procedures (SOPs) that were used) would improve their findability, accessibility, interoperability, and reusability (FAIR) in the nanosafety research field.
